Users Manual

ITM-1066A User Manual
Proprietary & Confidential Information iotTech Corporation, Taiwan
Doc. NO:
8. Appendix

Compliance with KDB996369 D03 OEM Manual
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C & PART 15 SUBPART E has been investigated. It is applicable to the modular
transmitter

2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition or
different operational conditions (example, uses another antenna) for a stand-alone modular transmitter in a host, host
manufacturer have to consult with module manufacturer for the installation method in end system.

2.4 Limited module procedures
This module is single modular. 
Not applicable.
2.5 Trace antenna designs
Not applicable.

2.6 RF exposure considerations
This modular transmitter should be used in the mobile conditions and 20cm from a person’s body, the host product
manufacture should be put those information in the end-product manual to the end users. If RF exposure statement and use
conditions are not provided, then the host product manufacture is required to take responsibility of the module through a
change in FCC ID(new application)

2.7 Antennas
This radio transmitter FCC ID : 2AWP5WM1066A has been approved by Federal Communications Commission to
operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in
this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this
device.
Manufacturer Part No. Antenna Type Maximum antenna gain
IOTTECH ITM-1066A PCB Antenna 1.376dBi for 2.4GHz
-1.840dBi for 5.150-5.250
GHz
0.745dBi for 5.725~5.825GHz
