Iota Engineering DLS-UI-27-40 Specifications

PRODUCT OVERVIEW
DC Output Voltage
Output Amperage
Input Voltage Range
Power Factor
27.2 VDC
40 Amps
108-264 VAC
>90%
IOTA REV 031315
P.O. BOX 11846 TUCSON, AZ 85734
[phone] • FAX [phone]
www.iotaengineering.com
DESCRIPTION
FEATURES
TECHNICAL SPECIFICATIONS
IOTA ENGINEERING
DLS-UI-27-40
PRODUCT SPECIFICATION SHEET
The DLS-UI-27-40 is a Power Factor Corrected Power Supply/Battery Charger that
converts 120 to 240 volts A.C. to 27.2 volts D.C. As a power supply, tightly controlled
regulation allows the user to operate any 24 volt nominal D.C. load up to the unit’s
rated output current. As a battery charger, the unit will maintain the battery, delivering
full-rated current when the battery capacity falls sufficiently low. The voltage is set to
deliver maximum current for the necessary period of time that minimizes undue stress
to the battery caused by heating of its cells. This helps to ensure the longest possible
life of the battery. Over time, as the battery nears full capacity, the unit will float-charge
the battery to prevent self-discharge of its cells.
27VDC 40A Power Factor Corrected Power Supply and Battery Charger
APPLICATION
Operation of 24VDC systems and accessories.
DC Output Voltage (No Load) approx.
Output Voltage Tolerance (No Load)
Output Amperage, Max Continuous
Output Voltage (Full Load) approx.
Maximum Power Output, Continuous
Ripple and Noise
Input Voltage Range (AC)
Input Voltage Frequency
Maximum AC Current (@ 120VAC)
Power Factor (@ Full Load)
Typical Efficiency
Max Inrush Current, Single Cycle
Short Circuit Protection
Overload Protection
Line Regulation
Load Regulation
Fan Control*
Thermal Protection
Working Temperature Range
Storage Temperature
Withstand Voltage (VDC)**
Dimensions
†
Weight
Input Cord
††
27.2V (DC)
+ or - .5%
40 Amps
>27.0V (DC)
1100 Watts
<100 mV rms
108 - 264 AC
47-63 Hz
11.5 Amps
>90%
80%
75 Amps
Ye s
>100%
100 mV rms
<1%
PROPORTIONAL
YES
0° - 40° C
-20° to 80° C
1700/1700/500
13″ x 8.3″ x 3.4″ (330mm x 211mm x 86mm)
9 lbs (4.08kg)
IEC C-14
*Proportional = Fan speed proportional to case temperature.
**Primary to Chassis/Primary to Secondary/Secondary to Chassis
†
See reverse side for detailed mounting specifications.
††
Requires country-specific C-13 cord (not supplied).
Switch-mode technology
Current limit, thermal and overload
protection
Lower operating temperature
Charging Jack option for normal and
high-stage battery charging applications
IEC Input Plug allows connection to all
global connection types.
POWER FACTOR
CORRECTION
Clean and steady DC Output oper-
ates your loads the way they were
intended, avoiding potential damage
to systems from errant DC voltage.
Built-in protection features guard
the unit against erratic line voltage
that can occur from shore power or
generator supplies.
Power Factor Correction provides more
efficient utility consumption and allows
for operation from a 15A circuit.
Universal Input accepts AC voltage
from 120 to 240 VAC.
POWER FACTOR
CORRECTION
Reverse Polarity Protection to protect
against damage from incorrect bat-
tery hook-up, using readily available
fuse types that are easy to replace.
Proportional fan control for
whisper-quiet operation.
ADDITIONAL FEATURES INCLUDE...