Iota Engineering DLS-48-20 Specifications

The DLS Series Battery Charger/Power Converter is warranted from defects in ma-
terials or workmanship for two years from date of retail purchase, and limits the rem-
edies to repair or replacement. This warranty is valid only in the continental United
States and Canada. For complete warranty details, contact Customer Service or visit
www.iotaengineering.com.
MODELS
IOTA REV 050113
WARRANTY
DLS-48-20
AC/DC POWER CONVERTER
DLS-48-20
MOUNTING FOOTPRINT
Disconnect the positive side of the battery before installation. Connect the positive
(red) and negative (black) terminal lugs to battery or load. Always use the proper
size wire based on the amperage of the converter and the battery. When connecting
to a battery, a breaker should be installed within 18″ of the battery, connecting the
battery positive to the line side of the breaker, and the DLS to the load side. Connect
“Chassis Bonding Lug” on the DLS to vehicle chassis or other grounding source.
Plug the DLS A.C. input cord into a 120 volt 3-wire grounded source. See chart
for maximum current draw and required input voltages. For complete installation
guidelines, refer to the installation manual.
INSTALLATION OVERVIEW
IOTA ENGINEERING PO BOX 11846 TUCSON, AZ 85734 TEL: [phone]-IOTA (4682) FAX: [phone] WEB: www.iotaengineering.com
PLUG CONFIGURATION