Datasheet

DIY IOT Electronics and Solutions
IOT-BOTS.COM LLC IBT-QTC-BG9X-AMC-DS Rev. 1.1 8
drain interrupt line and Q_IO GPIO line to be used by qJam device as additional
control or status signal.
So, any qJam compatible device could be located at the top of the Shield to bring
more feature to an IOT solution or project you are working on.
Pinout
Overview
qTop BG9x LTE GNSS AMC Shields could be used with most Arduino MKR
Compatible IOT boards (Main Board).
The following picture and Table 1 detail the pinout of qTop BG9x LTE GNSS AMC
Shield. Some pins are not connected by default to give more flexibility to our
product. So, they could be connected to the Shield blocks, using PCB jumpers, to
bring additional functionality, described in this document below.
Pic.7. qTop BG9x LTE GNSS AMC Shield Pinout