User's Manual

WA020100 - Smart Irrigation Controller
UMAOC001 Rev G
USER MANUAL
Page 26 of 33
2. Remove screws from housing
3. Remove housing from the cover. Be careful with internal antenna cable and wire connectors
4. Connect communication cable to programming connector and press the reset button. GND pin cable
must be connected in pin 1 of the circuit connector
Figure 8. Programming connector and reset button locations
5. Launch the PC software and follow indications.
Figure9. Screenshot of the PC software for Watersens updating
6. Once the Watersens is updated, press reset button to start normal operation.
7. Ensure the O-ring is placed correctly to avoid humidity inside the housing in wet environments.
8. Fit the housing and the cover and screw them
9. Perform a reset communication through Android app via NFC connectivity