User's Manual

12
space for the alignment peg to be fitted in between the 2x Azi Adjustment Screws. Remove the 2x Azi
Locking Screws from the mount base and insert them into the opening next. Secure the mount head by
tightening the Azi Locking Screws into the M6 holes on the tripod.
Figure 9. Attach the mount
Level the mount by adjusting the tripod legs. Use the build-in Bubble Level Indicator or an external
leveler for this purpose.
Step 4. Adjust latitude
Loosen the Latitude Locking Lever. Turn Latitude Adj. Knob to adjust the latitude until the arrow
points to the current latitude on the Latitude Scale. You may use the Allen wrench for easy adjustment.
Tighten the Latitude Locking Lever.
Figure 10. Adjust latitude
You may lift the Latitude Locking Lever handle by push the Push Button on this ratchet lever to
disengage gear teeth and rotate freely for quick adjustment.
Before pulling the Allen wrench out from the RA axle, make sure the RA gear switch is locked, as
shown in Figure 11. There are three RA axle locking positions for the CEM26 mount: Zero Position, East
and West position.
Figure 11. Allen wrench to lock the RA axle and storage
The Allen wrench can be stored on the bottom of the mount, as show in Figure 11.
Azi. Adj. Screw
Azi. Locking Screw
Lat. Adj. Knob
Latitude Scale
Wrench
Latitude Locking Lever
Push Button