User's Manual

3. CEM26 Mount Assembly

3.1. CEM26 Mount Assembly

NOTE: The CEM26 mount is a precision astronomical instrument. It is highly recommended that you

read the entire manual and become familiar with the nomenclature and function of all components

before starting the assembly.

WARNING: DO NOT rock the counterweight shaft rigorously. This may damage the

worm/drive gear system and such damage will not be covered by warranty.

Step 1. Remove mount head from package

The RA axle is locked by an Allen wrench (blue circle). Make sure it is inserted all the way in. Check

the R.A. and DEC Gear Switches and make sure they are at the unlock position before removing it from the

box.

Figure 7. CEM26 mount in a case

Step 2. Set up tripod

The mount has a 102mm base. Thread the Alignment Peg onto the tripod head, on top of a tripod

leg or between two legs depending on the latitude. Insert the Accessory Tray through the center rod and

secure the setup by tightening Locking Knob from underneath.

Figure 8. CEM26 tripod top

Step 3. Attach mount head

Before put the mount onto the tripod, make sure the RA gear switch is at lock position to prevent mount

head free swing by accident! Retract the 2x Azimuth (Azi) Adjustment Screws from both sides to leave ample