User Manual

43
NOTE: You can click on Settings and check RAW to see the real sky image at any time. Please
uncheck RAW during polar alignment for better results.
3. iPolar Calibration
If do not see the red cross on the screen, the iPolar has not been calibrated. Calibration is only needed
after iPolar is installed or any mechanical adjustment has been done on iPolar.
Rotate the RA axis of the mount roughly to the following three positions. Click on Confirm Position 1,
Confirm Position 2 and Confirm Position 3, respectively, to complete the calibration.
Note: If the software does not bring up Confirm Position 2, the initial RA axis is too aloes to the pole
axis. Just move the mount away a bit in altitude or azimuth direction and try it again.




位置 1



位置 2




位置 3
Position Position Position