Data Sheet
RoboClaw 120A/160A/200A Dual Channel Motor Controller Data Sheet
(c) 2016 Ion Motion Control. All Rights Reserved.
5
Control Interface (CTRL)
RoboClaw 120A, 160A and 200A use Molex style female connectors. The following tables list the pins and their available
functions. All pins are 5V tolerant and output 3.3V for compatibility with processor such as Rasberry Pi and Arduino. CTRL1
and CTRL2 pins are low side drivers at 40VDC, 3A per output. R/C pulse input, Analog and TTL can be generated from
any microcontroller such as a Arduino or Rasberry Pi. The R/C Pulse in pins can also be driven by any standard R/C radio
receiver. There are several user congurable options depending on the device used to control RoboClaw. To congure
RoboClaw, install Ion Studio and connect it to an available USB port.
Pin NAME UART TTL ANALOG R/C PULSE
FLIP
SWITCH
E-STOP HOME V-CLAMP
1 LB+
2 S4 X(3) Motor 1 (2) X(1)
3 5V+
4 S3 X(5) X(3) X(1)
5 GND
6 S2 TX X(4) X(4)
7 S5 X(3) Motor 2 (2) X(1)
8 S1 RX X(4) X(4)
Notes:
1. Control external voltage clamp circuit. Redirect the regenerative function of RoboClaw.
2. Input can be used for home switch and automatic homing on power up.
3. Optional E-Stop input conguration. Pin state changes error will clear or board reset required.
4. Supports mixed control or individual control of motor channel.
5. Supports TTL or R/C signals
USB
CTRL
DRV
ERR
STAT1
STAT2
ROBOCLAW - IONMC.COM
EN C
Mating Connector Part
Number: 794617-8
2 4 6 8
1 3 5 7