User Manual
MCP Series
Brushed DC Motor Controllers
MCP Series User Manual
56
1.9.10 Signal Graph
The signal graph shows how the input signal is modiî‚żed by the input settings. If no settings are
changed and the Min, Center and Max ranges are set to their defaults a straight slope will be
shown. The graph below shows the default signal slope.
Deadband
If an R/C signal is used to control a motor and deadband is added so the R/C controller stick
doesn't need to be exactly centered to stop the controlled motor. The graph would show an
horizontal in the middle of the graph at the 0 point. The lines would slop up and down an angle
like normal after the shown zero area. The size of the horizontal line at the 0 point will changes it
length based on how much deadband is set.