Data Sheet
MCP2xxx Dual Channel Motor Controller Data Sheet
(c) 2015 Ion Motion Control. All Rights Reserved.
13
Bridging Channels
The MCPs dual channels can be bridge to run as one channel, effectively doubling its current capability for one motor. Damage will
result if the MCP is not set to bridged channel mode before wiring. Download and install IonMotion PC utility. Connect the motor
controller to the computer using an available USB port. Run IonMotion and in general settings check the option to combine channels.
When operating in bridged channel mode the total peak current output can be 240 / 320 / 400 amps depending on the model. The
peak current run time is dependant on internal heat build up. Adequate cooling must be maintained.
Bridged Channel Wiring
When bridged channel mode is active the internal driver scheme for the output stage is modiî‚żed. The output leads must be wired
correctly or damage will result. Motor wire M1B is connected to M1A to create one side of the bridged driver. Motor wire M2A is
connected to M2B to create the other side of the bridged driver.
M2B B+ M1B
M2A B- M1A
MOTOR