Data Sheet
MCP2xxx Dual Channel Motor Controller Data Sheet
(c) 2015 Ion Motion Control. All Rights Reserved.
12
Firmware Update LED State
If all three LEDs begin to cycle on and off after powering on, the MCP has successfully been set to receive new rmware. Use
IonMotion on a Windows PC to install the new rmware to clear this state.
Automatic Battery Detection on Startup
If the automatic battery detection mode is enabled the Stat2 LED will blink to indicate the detected battery type. Each blink indicates
the number of LIPO cells detected. If automatic detection is used the number of cells detected should be conrmed on power up
before running the unit.
Undercharged or overcharged batteries can cause invalid auto detection.