Users Manual Part 5

IBA | 36-6 | Clinical User’s Guide
Volume 1 - Treatment Session
|Part VI - Using adaPT deliver in Standalone Mode Monitoring and Controlling the Treatment |
 Dosimetry values: the Preset and Actual values are displayed for the following:
 Global: meaning the entire beam, comprising all layers.
 Layer
Both at the global level and the layer level preset and actual values are displayed
for the following:
 Primary Meterset: expressed in Monitor Units
 Secondary Meterset: expressed in Monitor Units
 Time: expressed in seconds
 Layer
Specifically for the Layer level a preset and actual value is displayed for the
following:
 Open beam range: expressed in g/cm
2
In addition, progress for most activities is also visually indicated by the progress
bars to the right.
Performing Functions From the Monitor Panel
The Monitor panel is located at the bottom of the TREATMENT SCREEN, at the left hand
side. The panel contains a number of tabs from which you can monitor several
functions:
 Logs: for detailed information, refer to Section “Viewing Operator Logs” on
page 36-8.
 System Start/Resume Conditions: for detailed information, refer to Section
“Monitoring System Start/Resume Conditions” on page 36-8.
 Beam Line Checks: for detailed information, refer to Section “Monitoring Beam
Line Checks” on page 36-8.
 Nozzle cyclic checks: for detailed information, refer to Section “Monitoring
Nozzle Cyclic Checks” on page 36-10.
 TSS Interlocks: for detailed information, refer to Section “Monitoring TSS
Interlocks” on page 36-11.
 Positioning system status: for detailed information, refer to Section
“Monitoring the Positioning System Status” on page 36-12.
Use the arrow buttons at the top right to scroll through the horizontal list of tabs.