Users Manual Part 5

IBA | 36-4 | Clinical User’s Guide
Volume 1 - Treatment Session
|Part VI - Using adaPT deliver in Standalone Mode Monitoring and Controlling the Treatment |
In the Irradiation phase, the Equipment status button is disabled during actual
irradiation. To avoid redundancy of displayed data, access to the status panel
during Preparation phase is not provided.
The status panel is closed when the ‘Next’ button is clicked during Appointment
Selection, Session Definition, Beam Selection or Irradiation phases
 Perform beam functions: buttons enable you to perform the following functions:
 Start irradiation: for detailed information, refer to Chapter “Starting
Irradiation” on page 37-1 .
 Stop irradiation: for detailed information, refer to Chapter “Pausing and
Stopping an Irradiation” on page 38-1 .
 Pause irradiation: for detailed information, refer to Chapter “Pausing and
Stopping an Irradiation” on page 38-1 .
 Resuming after partial irradiation: for detailed information, refer to Chapter
“Resuming after a Partial Irradiation” on page 39-1 .
Working With the Dosimetry Panel
Note: To enable the Dosimetry state to progress, the Dose Counter Electronic Unit
(DCEU) must be reset.
Figure 36-3. Treatment Screen - Dosimetry Panel (typical)
progress
bars