Users Manual Part 4

Clinical User’s Guide IBA | 35-1 |
Volume 1 - Treatment Session
Chapter 35
Preparing the Equipment for
• • • • • •
Irradiation
Note: Screen representations throughout this chapter and throughout this part may
show ‘Control Mode: EMR-Centric’ or ‘Control Mode: DEV-Centric’ at the bottom.
When working in Standalone mode, you will notice that the mode indication reads
‘Stand-Alone’.
Getting Started With Equipment Preparation
To proceed with the equipment preparation, do any of the following:
 Double-click the desired beam.
 Click the beam from the List area of the BEAM SELECTION SCREEN and click Next
Process
Now you enter the third treatment session step: the preparation of the equipment.
The E
QUIPMENT PREPARATION SCREEN appears.
Equipment preparation for a setup beam and a treatment beam is different:
 Setup beam: refer to Section “Equipment Preparation for a Setup Beam” on
page 35-2.
 Treatment beam: refer to Section “Equipment Preparation for a Treatment
Beam” on page 35-8.