Users Manual Part 4
IBA | 34-4 |
Clinical User’s Guide
Volume 1 - Treatment Session
|Part VI
- Using adaPT
deliver
in Standalone Mode Proceeding to Beam Selection
|
Similar to the S
ESSION DEFINITION SCREEN, the Patient & Plan, Beam, and Layers tabs
are also available on the information area of the B
EAM SELECTION SCREEN.
Initially, most of the fields in the information area of the B
EAM SELECTION SCREEN are
blank; only the patient name, study, plan, and beam are listed in the list area. To have
the fields in the information area filled out, click the required beam in the list area.
Fields are filled in up to the lowest level that you select in the list area. E.g., if you
click the plan in the list area, only the patient, study, and plan information appear, not
the beam information.
To proceed to the next step in the irradiation process, i.e., to actually prepare the
equipment for irradiation, double-click the desired beam (or click the beam and click
Next in the rightmost corner at the bottom of the screen). You will proceed to the
Preparation step. For more information, refer to chapter “Preparing the Equipment
for Irradiation” on page 35-1.
WARNING The action of clicking on 'Next' in the Beam Selection phase of the
workflow entails the approval of the information related to the patient
treatment. The user shall make sure they read all treatment information
carefully before approving it by clicking on 'Next' and proceeding to
treatment.