Users Manual Part 4
Clinical User’s Guide
IBA | 34-1 |
Volume 1 - Treatment Session
Chapter 34
• • • • • •
Proceeding to Beam Selection
Note: Screen representations throughout this chapter and throughout this part may
show ‘Control Mode: EMR-Centric’ or ‘Control Mode: DEV-Centric’ at the bottom.
When working in Standalone mode, you will notice that the mode indication reads
‘Stand-Alone’.
Introduction
As soon as a beam appears in bold in the selection area, you can proceed to the next
step in the irradiation process, i.e., to actually select it for preparation for treatment.
When a beam is selected, the Next button in the rightmost corner at the bottom of
the screen becomes activated.
Click Next and you proceed to the Beam Selection step. For information, refer to
section “Selecting a Beam“ on page 34-2.