Users Manual Part 4

Clinical User’s Guide IBA | 33-1 |
Volume 1 - Treatment Session
Chapter 33
Including One or More Beams into a
• • • • • •
Session
Note: Screen representations throughout this chapter and throughout this part may
show ‘Control Mode: EMR-Centric’ or ‘Control Mode: DEV-Centric’ at the bottom.
When working in Standalone mode, you will notice that the mode indication reads
‘Stand-Alone’.
Introduction
From the list area you can select one or several baselined beams and include them
into the treatment session. All selected beams must belong to the same plan.
Note: Beams that are not baselined are not listed.
Performing General Activities on Screen
Selecting an Individual Beam
To select individual beams into the session:
1. Expand the list until a required beam is on display.
2. Double-click (or press Control and click) that beam. The beam is displayed in
bold in the list and the Next button in the rightmost corner at the bottom of the
screen becomes activated.
3. Repeat Step 1 and Step 2 to include any other beam that you want to include in
the treatment session.