Users Manual Part 2

Clinical User’s Guide IBA | 14-13|
Volume 1 - Treatment Session
|Part II - Using Treatment Room Equipment Installing and Removing Accessories into/from the Accessory Drawer or PBS
Removing Accessories from a DN_S Type Snout
The procedure to remove a block and accessory from a DN_S type snout is as
follows:
1. Pull the spring-loaded retaining pin to release the hinged retainer.
2. Open the hinged retainer.
3. Unlock the safety lock retaining the accessory installed on slot 2.
4. Remove the accessory from slot 2.
5. Unlock the safety lock retaining the block installed on slot 1.
6. Remove the block from slot 1.
7. Push the surface of the hinged retainer to close it; the spring-loaded retaining
pin automatically falls into its locked position.
CAUTION Do not use the spring-loaded retaining pin to close the hinged retainer.
When you try to use the spring-loaded retaining pin, you may crush
your fingers.