Users Manual Part 2

Addendum IBA | 18-3|
to the PTS User Documentation Set
|Part II - Using Treatment Room Equipment Troubleshooting Treatment Room Equipment |
Snout cannot move. The room configuration prevents the snout holder
from moving. Contact an operator to enable
snout motion in the room configuration.
DEVICE must be tared first. You need to tare the device DEVICE in order to be
able to move it.
Weight check must be
performed first on DEVICE.
Perform a weight check sequence on the device
DEVICE.
Jog request is not valid for
this device.
You pressed a jog button which is invalid for the
selected device (e.g. you pressed the ‘jog X’
button with the gantry selected). Press a jog
button that is valid for the selected device.
Motion Enable Button is not
pressed!
Press the Motion Enable Button of the hand-
pendant before moving.
Motion not allowed. The safety system (SRCU) prevents motion.
Contact an operator.
Device not enabled. Select a device before moving it.
Motor status NOK. The gantry motor status is in error. Contact an
operator.
Motion veto: ORIGIN
b
. The element ORIGIN prevents motion.
This element can either be a device, a check or
the check manager. Reset the check manager and
if the problem is still present, then contact an
operator.
Lock compensator before any
snout motion.
The compensator is not properly locked. Lock it
before moving the snout holder.
Lock block before any snout
motion.
The block is not properly locked. Lock it before
moving the snout holder.
Cancel docking activity. Cancel the docking activity currently selected in
order to be able to move the PPS.
Gantry must be horizontal to
proceed to snout homing.
Snout holder can only be homed with the gantry
in an horizontal position. Move the gantry to 90.0°
or 270.0° position before homing the snout
holder.
DID-B must be inserted
before moving the imager.
The imager can only be offset when DID-B is fully
inserted. Insert Did-B before offsetting the
imager.
a. During normal equipment operation, the word ‘DEVICE’ present in several of the
messages in this table is replaced by the name of the relevant device, according
to the circumstances.
Message Description