Users Manual Part 1

IBA | 11-10 | Clinical User’s Guide
Volume 1 - Treatment Session
|Part II - Using Treatment Room Equipment Using the Remote Positioning Controls |
 Corrected position: a corrected position becomes available once a given
treatment or setup position has been corrected using the Patient Position
Verification System (PPVS), adaPTinsight. As such, a corrected position is only
available as a labeled target position when a treatment or setup beam is selected
and after the alignment process is complete.
Depending on the stage of the workflow, you may choose among the available target
positions.
Selecting a Target Position
To make a selection among the available target positions, click the dot next to the
required target position in the ‘Target Positions’ part of the remote positioning
controls panel. The dot becomes blue.
Figure 11-6. Target Positions Commands
(typical)
The ‘User Preset’ target position, which appears on the left side of the ‘Target
Positions’ commands, is not selectable.
To select a user preset as a target position, use the U
SER PRESETS MENU at the
bottom of the remote positioning controls panel.
Target positions
commands