Users Manual Part 1

Clinical User’s Guide
IBA | 9-37|
Volume 1 - Treatment Session
|Part II
- Using Treatment Room Equipment Using the Wireless Hand-Pendant
|
Figure 9-29. Digital Imaging Devices - CBCT Preparation Screen
(typical)
4. Use the Move button on the DIGITAL IMAGING DEVICES - CBCT PREPARATION
SCREEN to put the digital imaging devices in place for CBCT acquisition
(orthogonal imager).
a. Touch and hold the Move button.
b. While holding the Move button, press and hold the MEB buttons on the
wireless hand-pendant until the device reaches the target position.
A green check mark overlays the Move button once the device has reached the
target position and the workflow progresses automatically onto the next screen.
The CBCT D
RY RUN SCREEN appears.
The device icon in the Device Selection bar at the bottom of the screen is also
overlaid by a green check mark once all required movements are complete.
Note: You may at this point continue the CBCT acquisition procedure using
adaPTinsight, without completing the dry run.