Users Manual Part 1

Clinical User’s Guide IBA | 9-35|
Volume 1 - Treatment Session
|Part II - Using Treatment Room Equipment Using the Wireless Hand-Pendant |
A green check mark overlays the Move button once the device has reached
the target position.
To move the accessory drawer into the beam path, proceed as follows:
a. Touch and hold the Move Accessory Drawer Into the Beam Path button.
Figure 9-27. Move Accessory Drawer Into the Beam Path Icon
b. While holding the Move Accessory Drawer Into the Beam Path button,
press and hold the MEB buttons on the wireless hand-pendant until the
device reaches the target position.
A green check mark overlays the Move button once the device has reached
the target position.
Once both Move buttons are overlaid by a green check mark, the workflow
progresses automatically onto the next screen. The PPS - CBCT P
REPARATION
SCREEN appears.
The device icon in the Device Selection bar at the bottom of the screen is also
overlaid by a green check mark once all required movements are complete.