Installation Guide

Insert the pin fob tool into the
hole next to the cable.
2a
Part 3: Removal & Recoiler Replacement
Unplug the power supply from
the outlet.
1
Use the scraper removal
tool (DNTX93) to break the
adhesive bond between the
recoiler and xture.
5
Slide the sleeve off the S-Pen
clip assembly.
3
Pivot the fob tool back to
remove the retainer.
Note: Be careful not to lose
the clip when removing.
2b
Slide the sleeve off the S-Pen
clip assembly.
4
Recoiler Replacement:
Use a Philips head screw-
driver to remove the screw
holding the panel on the
bottom of the tray.
6
Remove the panel.
7
Use a Philips head screw-
driver to remove the screws
holding the recoiler.
8
Use a Philips head screw-
driver to remove the screws
holding the cable guide.
9
Remove the old recoiler and
cable guide assembly.
10
Insert the new recoiler and
cable guide assembly. Ensure
that tether emerges through
the tray and that the screw
holes on both are aligned with
scew holes in the tray.
11
Replace the screws for the
cable guide.
12
Replace the screws for the
recoiler.
13
Replace the panel.
14
Replace the panel screw.
15