Installation Guide

CONTENTS: One pad saturated in 75%
Isopropyl Alcohol
DIRECTIONS: Apply topically as
needed to cleanse
surface mounting area
.
FOR EXTERNAL USE ONLY
KEEP OUT OF REACH OF
CHILDREN
KEEP AWAY FROM EYES
AND FIRE
Use the provided alcohol wipe
to clean the end of the S-Pen.
Allow it to dry completely.
8
Place the S-Pen, with the logo
and button facing up, into the
bottom stylus clip piece.
11
E
Pull the red tab from the
adhesive on the bottom stylus
clip piece (identable by the
smaller gap in the end of the
piece).
10
E
Lift the tether from the
recoiler.
12
Insert the end of the tether
into the gap in the back of the
stylus clip.
14
E
Apply pressure to the 2 halves
of the stylus clip against the
S-Pen for at least 10 seconds.
17
F
E
Place the top stylus clip piece
on to the S-Pen. Snap the
pieces together.
16
F
A
Pull the red tab from the
adhesive on the top stylus
clip piece.
15
F
Insert the tether through the
outer sleeve.
13
Insert the clip assembly into
the outer sleeve piece.
18
Insert the retainer into the
assembly.
19
D
Place the S-Pen into the tray.
20
G
Plug the power cable into a
power supply.
21
Plug the power supply into a
power outlet.
22
If the S-Pen loses Bluetooth
connection with the device,
insert a small pin tool (such
as a paper clip) into the
hole to press the button to
reestablish the connection.
Make sure that the S-Pen is
correctly docked in the tray.
23
Align the provided piece of
tape to the split line near the
butt cap on the S-Pen. Wrap
the tape around the S-Pen.
9