Installation Guide

Insert the retainer into the
hole on the sleeve cover and
through the bottom piece of
the clip. It should sit ush
when properly assembled.
13
Place the S-Pen into the
display.
14
F
Orient the sleeve cover so
that the gap will align with the
cable. Slide the cover up the
length of the S-Pen and over
the 2 pieces of the stylus clip
12
C
Gap
Cable
Plug the power cable into a
power supply.
15
When docked, the LED on
the tray will illuminate Blue. It
will change to Red when the
S-Pen is lifted.
17
Plug the power supply into a
power outlet.
16
Place the top half of the stylus
clip over the S-Pen and tether.
11
E
If the S-Pen loses Bluetooth
connection with the device,
insert a small pin tool (such
as a paper clip) into the
hole to press the button to
reestablish the connection.
Make sure that the S-Pen is
correctly docked in the tray
18
Place the end of the tether
into the channel at the back of
the bottom stylus clip.
9
Pull the tether from the
recoiler.
8
A D
Prepare the stylus for
installation into the clip by
making sure that it is clicked
open.
10a
D
With the S-Pen clicked open,
place it into the cavity of the
bottom stylus clip piece. The
button on the S-Pen should
face upwards.
10b