Installation Guide

ManualsBrandsInVue Security Products ManualsElectronicsStanding S Pen Recoiler

Place the recoiler in the

desired location and apply

pressure for at least 10

seconds.

Assembled Stylus

Clip

Qty. 1

Outer Sleeve

Qty. 1

Bottom Stylus Clip

Piece

Qty. 1

Top Stylus Clip

Piece

Qty. 1

Key Fob Tool

Qty. 1

Samsung S-Pen Non-Alarming Display

Installation Guide

Please read the entire guide before beginning the installation and follow all steps as

described. Please keep this manual for future reference.

Part 1: Recoiler Installation

System

Components:

DNAZ90

Custom S-Pen

Cup Non-Alarming

Display

Qty. 1

CAUTION!

24 hours is required for all adhesives to completely cure and reach full adhesive strength.

Please do not use the products immediately after the placement of the adhesive.

Clean the xture with the

alcohol wipe provided.

Let it dry completely.

C D E G

Retainer

Qty. 2

Remove the sleeve and

separate the upper and lower

halves of the stylus clip.

Peel the liners from the

adhesives on the bottom of

the recoiler.

Part 2: Tether Installation

Remove the pin cover from

the fob tool.

Insert the pin into the hole

opposite of the cable.

Pivot the fob tool back to

remove the retainer.

Note: Be careful not to lose

the clip when removing.

C D

Optional:

If routing the cable across a

xture, press the power cable

down into the channel on the

bottom of the stand.

Optional:

If desired, route the cable

through a hole or slot in the

xture.

Summary of content (3 pages)

PAGE 1
Samsung S-Pen Non-Alarming Display Installation Guide ! Please read the entire guide before beginning the installation and follow all steps as described. Please keep this manual for future reference. System Components: A B C D DNAZ90 Assembled Stylus Outer Sleeve Custom S-Pen Qty. 1 Cup Non-Alarming Clip Qty. 1 Display Qty. 1 ! CAUTION! E F Bottom Stylus Clip Top Stylus Clip Piece Piece Qty. 1 Qty. 1 G Retainer Qty. 2 Key Fob Tool Qty.
PAGE 2
A 8 Pull the tether from the recoiler. E D 9 C D Place the end of the tether into the channel at the back of the bottom stylus clip. 10a Prepare the stylus for installation into the clip by making sure that it is clicked open. 10b With the S-Pen clicked open, place it into the cavity of the bottom stylus clip piece. The button on the S-Pen should face upwards. F Cable Gap 11 Place the top half of the stylus clip over the S-Pen and tether.
PAGE 3
Part 3: Removal 1a Insert the pin fob tool into the hole next to the cable. 1b Pivot the fob tool back to remove the retainer. 2 Note: Be careful not to lose the clip when removing. 4 Slide the sleeve off the pen and separate the upper and lower halves of the stylus clip. 3 Unplug the power supply from the outlet. Use the scraper removal tool (DNTX93) to break the adhesive bond between the recoiler and fixture.