Installation Guide

ManualsBrandsInVue Security Products ManualsElectronicsCustom Tray S Pen Display

Insert the end of tether through the hole in the bottom stylus piece. Do NOT

lay it down in the cavity.

Place the recoiler in the

desired location and apply

pressure for at least 10

seconds.

Assembled Stylus

Clip

Qty. 1

Outer Sleeve

Qty. 1

Bottom Stylus Clip

Piece

Qty. 1

Top Stylus Clip

Piece

Qty. 1

Key Fob Tool

Qty. 1

Samsung S-Pen Tray Recoiler

Installation Guide

Please read the entire guide before beginning the installation and follow all steps as

described. Please keep this manual for future reference.

Part 1: Recoiler Installation

System

Components:

DNAZ85

Custom S-Pen

Tray Non-Alarming

Display

Qty. 1

CAUTION!

24 hours is required for all adhesives to completely cure and reach full adhesive strength.

Please do not use the products immediately after the placement of the adhesive.

Clean the xture with the

alcohol wipe provided.

Let it dry completely.

C D E G

Retainer

Qty. 2

Remove the sleeve and

separate the upper and lower

halves of the stylus clip.

Peel the liners from the

adhesives on the bottom of

the recoiler.

Pull the tether from the

recoiler.

Part 2: Tether Installation

Remove the pin cover from

the fob tool.

Insert the pin into the hole

opposite of the cable.

Pivot the fob tool back to

remove the retainer.

Note: Be careful not to lose

the clip when removing.

A A

A C

C D

Optional:

If desired, route the cable

through a hole or slot in the

xture.

Slide the tether end back and

place it in the depression on

the inside of the bottom stylus

piece.

Summary of content (3 pages)

PAGE 1
Samsung S-Pen Tray Recoiler Installation Guide ! Please read the entire guide before beginning the installation and follow all steps as described. Please keep this manual for future reference. System Components: A B C D DNAZ85 Assembled Stylus Outer Sleeve Custom S-Pen Qty. 1 Tray Non-Alarming Clip Qty. 1 Display Qty. 1 ! CAUTION! E F Bottom Stylus Clip Top Stylus Clip Piece Piece Qty. 1 Qty. 1 G Retainer Qty. 2 Key Fob Tool Qty.
PAGE 2
C C Cable Gap 11a Prepare the stylus for installation into the clip by making sure that it is clicked open. 11b With the S-Pen clicked open, place it into the cavity of the bottom stylus clip piece. The button on the S-Pen should face upwards. 12 Place the top half of the stylus clip over the S-Pen. 13 Orient the sleeve cover so that the gap will align with the cable. Slide the cover up the length of the S-Pen and over the 2 pieces of the stylus clip 16 Plug the power cable into a power supply.
PAGE 3
PMN: CUSTOM TRAY S PEN DISPLAY FCC ID: 2AFR8F1754A IC: 23313-F1754A FCC WARNING STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Part 18 of the FCC rules.