Installation Guide

DOLPHIN

rth Ground

Wire Lug

8A Make the Connections

Connect the required wires using the Dolphin crimps provided in the IXM Install Kit (or any similar crimps) and a ratchet style

crimping tool. Insert two wires (no stripping required) into the open end of the crimp and then using the crimping tool, clamp

down on the middle of the crimp.

8B Connect Earth Ground

Connect the lug of the Earth Ground wire directly to the front of the mounting plate using one of the Wall

mounting screws. Ensure that the lug is secured tightly as to make the necessary contact between the

device and the mounting plate. Connect the other end of the Earth Ground wire to the Earth Ground

connection of the install site with a crimp.

Ensure all required connections are made to each device in the setup prior to turning on the power.

Checklist:

Connections for Power & Grounds (DC or PoE)

Connections for Communications (Ethernet, RS-485 or RS-232)

Connections for Operation (ACP or DAC)

INVIXIUM