Installation Guide

Install the mounting blocks (usually two 11/16” blocks on the bottom and one 1/2” on the top) to the hinged side

of the bookcase unit. Modify the blocks or use blocks of a di erent thickness to create appropriate height and

margin for your application.

Use the mounting diagram to install hinge plate # 1 to the bottom of the book case.

Prior to installing the upper hinge on an

outswing

door to the bookcase, an access hole must be drilled

through the top of the bookcase. Use the diagrams for the location of this hole. Predrill a small hole from

the top of the bookcase. Then drill a 5/8” hole from the inside of the bookcase through the top to avoid tear

out inside the bookcase .

Mount hinge plate #2 to the top of the bookcase. Thread the included setscrew/capscrew into the threaded hole.

Install Bookcase

For an

outswing

door, you will work from the backside of the Invisidoor to put it into place on the lower

hinge pin and install the capscrew through the top.

Lift the bookcase into the opening. Set the hinge on the bottom of the bookcase onto the pin of the hinge plate

on the threshold. Align the upper hinges and screw the set screw into the hinge plate on the header.

Verify the  t of the trim against the installed Invisidoor. A slight gap between the bookcase and face frame is

necessary to allow clearance for the bookcase to swing. Adjust hinges as needed by using slotted holes in hinge

plates. Predrill holes for remaining screws in each of the hinge plates. The provided 2-1/4” screws will be used to

secure hinge plate 4 through the upper jamb into the door header.

5/16”

5-15/16”

Inswing

5/16”

5-15/16”

Inswing

1-11/16”

2-5/8”

Outswing

Bottom view

Front view

1-11/16”

2-5/8”

Install Hinges to bookcase

Outswing

Hinge Plate #1

on bottom of

bookcase

Hinge Plate #2

on top of

bookcase

Install the mounting blocks (usually two 11/16” blocks on the bottom and one 1/2” on the top) to the hinged side