Installation Guide

Hinge plate #1-bottom of bookcase Hinge plate #2-threaded hole Hinge plate #3-with washers Hinge plate #4- upper door jamb
Use diagrams to install hinge plate #3 to threshold/ oor.
Place the two steel washers and the bronze bearing onto the hinge pin as shown.
Install a hinge plate #4 to the header. Shim the jamb as needed at location of pivot hinge for a solid mounting area
with longer hinge plate screws mounted into header for  nal installation.
4”
1-3/4”
Inswing
6”
1”
Inswing
Outswing
1-3/4”
4”
Outswing
Install Hinges to opening
Install Hinges to opening
6”
1”
Hinge Plate #3
on threshold
Hinge Plate #4
on upper jamb
Use the diagrams to identify locations for the pivot hinge to be installed on the left or right side of the unit as either
an outswing (which pulls out toward the bookcase side) or an inswing (which rotates away from the bookcase side).
In most cases, the bookcase face frame will be  ush with the drywall. Trim will later be mounted over the drywall and
bookcase face frame, spanning across the jamb.
mounted on top of bookcase
mounted on threshold
Inswing
Outswing