Installation Guide

ManualsBrandsInvisiDoor ManualsBuilding materials36 in. Red Oak Extra Shelf Accessory for 36 in. Bookcase Door

Required Tools:

Cordless drill/screwdriver

Drill bits-3/32” and 5/8”

Level

¼” Hex driver

Preparation

●

Check the opening into which the Invisidoor will be installed to verify that it is

plumb and level. Correct operation and appearance of the Invisidoor requires that

the opening be level and plumb or you need to make accommodations for it.

●

The Invisidoor pivot hinge is designed to be installed with the bottom hinge

plate secured to stable, solid wood. This can be accomplished by using the

optional ready-to-assemble jamb/threshold. This can also be accomplished by

mounting to an alternative base that o ers adequate support for weight of the

unit and holding power for the screws.

●

It is recommended that you test mount the hardware and install the Invisidoor prior

to applying stain and  nish coat. This will eliminate the chance of damaging the

 nished product during the process of mounting the hinges and adjusting the unit.

Installation Instructions

nvisi

oor

Summary of content (4 pages)

PAGE 1
Invisi Door TM Installation Instructions Required Tools: Cordless drill/screwdriver Drill bits-3/32” and 5/8” Level ¼” Hex driver Preparation Check the opening into which the Invisidoor will be installed to verify that it is plumb and level. Correct operation and appearance of the Invisidoor requires that the opening be level and plumb or you need to make accommodations for it. ● ● The Invisidoor pivot hinge is designed to be installed with the bottom hinge plate secured to stable, solid wood.
PAGE 2
Use the diagrams to identify locations for the pivot hinge to be installed on the left or right side of the unit as either an outswing (which pulls out toward the bookcase side) or an inswing (which rotates away from the bookcase side). In most cases, the bookcase face frame will be flush with the drywall. Trim will later be mounted over the drywall and bookcase face frame, spanning across the jamb.
PAGE 3
Install Hinges to bookcase Install the mounting blocks (usually two 11/16” blocks on the bottom and one 1/2” on the top) to the hinged side of the bookcase unit. Modify the blocks or use blocks of a different thickness to create appropriate height and margin for your application. Front view Bottom view Use the mounting diagram to install hinge plate # 1 to the bottom of the book case.
PAGE 4
Install Support Foot Mount bracket to the side of bookcase. Bracket must be attached near the face frame to allow enough clearance to swing past the jamb. Align the tapered stop to the location of the bolt when the door is in the closed position, mark the location, fasten it with the supplied tape/and or screw. Install Trim Inswing: Trim on both sides and the top of the door are mounted to the wall and serve as a stop for the door.