Instructions / Assembly
Outswing
:
Trim on the hinge side of the bookcase and the top will be attached to the wall,
but the non-hinged side trim will be attached to the bookcase to act as a stop. It is
recommended that the trim overlay the face frame by 3/4” and be mounted very
securely to withstand the opening and closing of the door. The trim across the
top of the door must be mounted to allow clearance for the door to swing below
it. Also, allow clearance for the door-mounted trim to swing freely from the upper
piece of trim as well as clear the oor.
Remove Invisidoor from the opening and remove hinge plates from the case.
Do a nal sanding of project. Apply stain and nish coat of choice according to
manufacturer’s directions. Reinstall hinges by mounting all screws. Reinstall
InvisiDoor into opening and permanently install trim.
7-25 -12
I
nvisi
D
oor
Inswing
Outswing
Install Support Foot
Mount bracket to the side of bookcase. Bracket must be attached near the face frame to allow enough clearance to
swing past the jamb. Align the tapered stop to the location of the bolt when the door is in the closed position, mark
the location, fasten it with the supplied tape/and or screw.
Install Trim
Finish Bookcase
Inswing
:
Trim on both sides and the top of the door are mounted to the wall and serve as a
stop for the door. Avoid using trim that has a narrow inside edge as it will not hold
up as a stop. A 3/4” thick molding is recommended. It is also recommended that the
trim overlay the face frame by 1/2”- 3/4”.
A wide variety of trim styles will work for the inswing mounted Invisidoor. Corner
blocks, mitered corners, or built out crowns can all be used without interfering with
the function of the door.
Install Bookcase
For an
outswing
door, you will work from the backside of the Invisidoor to put it into place on the lower
hinge pin and install the capscrew through the top.
Lift the bookcase into the opening. Set the hinge on the bottom of the bookcase onto the pin of the hinge plate on
the threshold. Align the upper hinges and screw the set screw into the hinge plate on the header. Use of Locktite can
prevent set screw from twisting loose over time.
Verify the t of the trim against the installed Invisidoor. A slight gap between the bookcase and face frame is neces-
sary to allow clearance for the bookcase to swing. Adjust hinges as needed by using slotted holes in hinge plates.
Predrill holes for remaining screws for each of the hinge plates. The provided 2-1/4” screws will be used to secure
hinge plate 4 through the upper jamb into the door header.