Instructions / Assembly

4”
1-3/4”
Inswing
6”
1”
Inswing
5/16”
5-15/16”
Inswing
Outswing
Inswing
5/16”
5-15/16”
Inswing
1-11/16”
2-5/8”
Outswing
1-3/4”
4”
Outswing
1-11/16”
2-5/8”
Install Hinges to bookcase
Outswing
6”
1”
Hinge Plate #3
on threshold
Hinge Plate #4
on upper jamb
Hinge Plate #1
on bottom of
bookcase
Hinge Plate #2
on top of
bookcase
Install a hinge plate #4 to the upper jamb. Shim the jamb as needed at location of pivot hinge for a solid mounting
area with longer hinge plate screws mounted into header for  nal installation.
Use diagrams to install hinge plate #3 to threshold/ oor.
Place the two steel washers and the bronze bearing onto
the hinge pin as shown.
Install the mounting blocks (usually two 11/16” blocks on the bottom and one 1/2” on the top) to the hinged side of the
bookcase unit. Use blocks of a di erent thickness to create appropriate height and margin for your application.
Bottom view
Use the mounting diagram to install hinge plate # 1 to the bottom of the book case.
Prior to installing the upper hinge on an
outswing door to the bookcase, an access hole for the set screw must be
drilled through the top of the bookcase. Use the diagrams for the location of this hole. (Predrill a small hole from the
top of the bookcase. Then drill a 5/8” hole from the inside of the bookcase through the top to avoid tear
out inside the bookcase . )
Mount hinge plate #2 to the top of the bookcase. Thread the included setscrew/capscrew into the threaded
Cross section