Instructions / Assembly

Install Hardware to Top of Bookcase
Attach Hardware to Valance
Fasten the plate to the top of the
pivoting side of the bookcase as
shown (Fig.#5).
Fasten the plate with roller to
the top of the rolling side of the
bookcase as shown (Fig.#6).
5-1/2”
2-3/4”
1-3/4”
4-1/2”
1-3/4”
4-1/2”
Drill a 5/8” hole through the valance at the location shown. Fasten plate to the bottom of the valance
on the pivoting side of the bookcase as shown. Cut the aluminum track to length and fasten to the bot-
tom of valance. Fasten a second plate to the top of the balance. The hole in this plate must be directly
above the hole on the bottom of valance. Insert pin to verify alignment. The aluminum track must
extend against the trim on the end opposite the plate. The gap between the plate and track should be
no more than 7” (Fig.#7).
(Fig.#5)
(Fig.#6)
Wood
2 x 4
Wood
2 x 4
(Fig.#7)
7” maximum
Aluminum track
Back edge that mounts to wall