Instructions / Assembly

7-8-13

nvisi

oor

Set the valance on top of the bookcase with the roller  tting into the

track mounted to the bottom of the valance. Use a ¼” spacer between

the valance and bookcase to create enough space for the roller to

move freely in the track. Use supplied screws to

fasten the valance to the wall. Be certain that screws are held into

header or studs of wall for secure installation (Fig.#9).

Remove the valance and bookcase from the opening and remove all hardware from each piece. Do a  nal

sanding of project. Apply stain and  nish coat of choice according to manufacturer’s directions. Reinstall

hardware to the bookcase to mount bookcase back into opening.

*CSH stands behind the material and workmanship of the hardware kit and bookcase but can not be held liable for faulty installation.

Finish Bookcase

(Fig.#8)

1/8”

Bookcase

Front view

Install washers onto the  oor mounted

baseplate. This method allows you to make

adjustments to make sure that bookcase is lev-

el from side to side. Typically, a total of 6 wash-

ers will be used. The bronze bearing washer

is intended to be the top washer to keep the

bookcase pivoting freely. Move the bookcase

into place with the plate of the pivoting side

set onto the  oor-mounted base plate and the

wheel set onto the  oor-mounted track.

Check to make sure bookcase is level. Add

or remove steel washers as necessary to make

bookcase level. There should be 1/8” of

clearance between the bottom of the

bookcase and the  oor mounted track (Fig.#8).

Install Bookcase

(Fig.#9)