Instructions / Assembly

Page 8
OUTSWING ACCESS HOLE CREATION
For the outswing InvisiDoor, an access hole needs to be made.
E. HANGING THE INVISIDOOR BOOKCASE
1. Stand the InvisiDoor bookcase upright and
bring it to the backside of the opening.
2. Carefully lift the bookcase into the opening
and set the bottom hinge of the door onto the
bottom hinge plate of the threshold.
3. Align the upper hinge plates and fasten them
together using the cap screw. Test the opening
and closing of the door.
(2)
(3)
(1)
1. With the top of the bookcase facing you, pre-drill a small pilot hole
through the center of the pivot hole.
2. Remove the top hinge plate.
3. From the inside of the bookcase, center a 5/8” drill bit on the pilot hole
and drill through.
4. Re-install the top hinge plate. Make sure the pivot hole aligns perfectly
with the new 5/8” hole you just made.
HANGING THE OUTSWING INVISIDOOR
Installation for the outswing InvisiDoor bookcase di ers slightly, as described below:
1. Stand the InvisiDoor bookcase upright and bring it to the front of the
opening.
2. Carefully lift the bookcase into the opening and set the bottom hinge of
the door onto the bottom hinge plate of the threshold.
3. Align the upper hinge plates and insert the set screw into the access hole.
4. Keep threading the set screw until it passes through the pivot holes of
both top hinges and presses tightly against the jamb above the opening.
Test the opening and closing of the door.