Manualshelf

Instructions / Assembly

ManualsBrandsInvisiDoor ManualsDoors & Windows34.88 in. x 79.88 in. Flush Mount Ready-to-Assemble Unfinished Maple Interior Bookcase Door with Trim Molding
12345678910
Page 7
D. INSTALLATION OF BOOKCASE HINGE PLATES
1. With the top of the bookcase still facing you, make a
mark 5-15/16” from the front edge of the bookcase face
frame. Place the center of hinge plate #2 at this mark.
2. While holding the hinge plate at the 5-15/16” line, align
Hinge plate #2 - threaded hole
mounted on top of bookcase
the center of the pin hole so that it sits 5/16” from the side of the bookcase.
3. Pre-drill pilot holes for the slotted holes.
4. Fasten the hinge plate to the top of the bookcase with two screws.
5. Double check the location of the pivot point to ensure proper
placement. Drive the rest of the screws securely into the hinge plate.
6. Take hinge plate #1 (non-threaded hole), and, using the same
measurements, fasten to the bottom of the bookcase.
Note: Both top and bottom hinges should point in the same direction.
(3)
(5)
TOP OF BOOKCASE BOTTOM OF BOOKCASE
OUTSWING HINGE PLACEMENT
For the outswing InvisiDoor, the placement of the hinge plates di er, as shown below:
TOP OF BOOKCASE BOTTOM OF BOOKCASE
5-15/16”
5/16”
1-11/16”
1-11/16”