Instructions / Assembly

Page 6
5. Take hinge plate #4 (non-threaded hole) and measure 6”
from the front of the top jamb header to the center of the
large pin hole. The center of the hinge plate also needs to be
1” from the vertical jamb. Make appropriate marks.
6. Pre-drill pilot holes through the slotted holes of the hinge
plate.
7. Drive 7/8” screws through the slotted holes, fastening
the hinge to the top jamb header. Double-check
measurements.
8. For the remaining round holes, use long, 2-1/4” screws to
further secure the hinge to the structural header.
Hinge plate #4- non-thread-
ed hole mounted on upper
door jamb
(5)
(8)
OUTSWING HINGE PLACEMENT
For the outswing InvisiDoor, the placement of the hinge plates on the jamb/threshold di er (as shown below).
BOTTOM THRESHOLD
UPPER JAMB HEADER
C. INSTALLING THE MOUNTING BLOCKS
The InvisiDoor is designed to have mounting blocks installed on the top and bottom of
the bookcase to build up the location of the hinges.
Usually, it is two 11/16” blocks on the bottom and one 1/2” block on the top of the
hinged side of the bookcase unit.
If needed, use blocks of a di erent thickness to create appropriate height and margin
for your application.
1. Use screws to fasten the necessary blocks to the bottom of the bookcase
(hinge side). Check the length of the screws to ensure that the screws will not
penetrate through the top/bottom of the bookcase.
2. Repeat this process for the top of the bookcase.
1”
6”