Instructions / Assembly

Page 5
1”
6”
Watch our installation video
by scanning the QR code:
INVISIDOOR INSTALLATION INSTRUCTIONS
WHAT YOU WILL NEED:
- brad nail gun
- 1” brads
- drill
- drill bits
- tape measure
BEFORE YOU BEGIN:
This installation guide details the instructions of an inswing
door. Outswing diagrams will also be shown.
- speed square
- bubble level
- Phillips screwdriver
- 1/4” hex driver
- safety glasses
A. PRE-INSTALL PREPARATION
• Check the opening into which the InvisiDoor will be installed to verify that it is plumb and
level.
• Verify that your opening has the appropriate sized opening (height and width) that is
needed for the size of the InvisiDoor you will install.
• Determine which side your bookcase door will pivot from. This guide shows a right-
pivoting door.
• Remove any cabinet doors prior to installation.
B. INSTALLATION OF FRAME HINGE PLATES
This InvisiDoor kit comes with four hinge plates:
Hinge plate #2 - threaded hole
mounted on top of bookcase
Hinge plate #3 - with bearing
mounted on threshold
Hinge plate #1 - mounted
on bottom of bookcase
Hinge plate #4- non-thread-
ed hole mounted on upper
door jamb
1. Take hinge plate #3 and place the two steel washers and the
bronze bearing onto the hinge pin.
2. On the bottom threshold, make a mark 1” from the vertical
jamb to the center of the hinge. Make another mark 6” from
the front of the threshold which will mark the center of the
hinge pin.
3. Put the hinge plate into location and predrill pilot holes
for the slotted holes. Using the screws provided, fasten the
hinge plate to the bottom threshold.
4. Double check the measurements and adjust as needed. Drill
pilot holes and fasten screws into remaining holes.
(1)
(2)
(3)
(4)