Instructions / Assembly

Page 2
B. SLIDING IN THE SIDE PANELS
1. With the face frame lying face down on the  at protected surface, run
a modest bead of glue in the two shoulders of the vertical groove.
2. Only the biscuit-style fasteners are pressed into the deepest recess, so
there is no need to put a full bead of glue in this recess.
3. Align the side panel onto the face frame. Make sure that the dadoed
grooves of the side panel line up properly with the dadoes of the face
frame.
4. Press the panel into the vertical slot. Use a rubber mallet to ensure a
tight  t. Wipe o any excess glue with a damp rag.
5. Repeat steps 1 - 4 for the other side panel.
C. SLIDING IN THE HORIZONTAL PANELS
1. Apply glue to the horizontal groove on the face frame.
2. Apply glue to the grooves on both side panels.
3. Slide the horizontal panel into place. The dovetail shape of the end of each
panel needs to slide down into each side panel at the same time. Use a
mallet to ensure that the panel is seated completely into the groove.
4. Repeat steps 1 - 3 with each of the other panels. Wipe o any excess glue
with a damp rag.
(1)
(2)
Apply glue here
(3)
(4)
(5)
(1)
(3)
D. INSTALLING THE BACK PANEL
1. Working quickly before the glue dries, test  t the back panel onto the
bookcase. Ensure that the board  ts properly, including the grooves on the
back panel.
2. When satis ed, remove the back panel and apply glue into each of the
grooves that the back panel will  t into.
(1)