Installation Guide

3
• Bottom shelf of the bookcase is ⅛”
below the top edge of the bottom
face frame rail.
The pocket on the bottom of the Invisidoor is
approximately 1 ⅜” deep.
(Bottom of the bookcase to the bottom edge of the face
frame.)
The thickness of Hinge Plate #3, plus the 3 washers,
plus Hinge Plate #1 = ⁄”
That leaves ⁄” space plus whatever desired
clearance gap between the bottom of the face frame
and the floor surface where the bottom hinge plate
is attached.
(The required gap height will depend on how level the
floor is within the swing of the bookcase.)
Example:
Using two ½” thick plywood blocks attached to the
bottom of the bookcase plus the two Hinge Plates
and three washers will total 1 ⁄”, producing a gap of
approximately ⁄”.
Decrease or increase this gap by adjusting the thickness
of the blocks.
• Sides and back run down past the bottom shelf, but not as far as the face frame (forms a pocket on
the bottom of bookcase. Sides and back extend ¾” below the bottom shelf. The face frame extends
approximately 1⅜” below the bottom shelf)
• Mounting blocks are screwed into this pocket. The thickness of the blocks may need to be adjusted based on
the clearance and spacing needed for door.
Top of Bookcase Top of Bookcase
¾” Overhang
Face Frame
Approx. ⁄” Face Frame
centered on bookcase
½” Plywood
Back
¾” Plywood
Sides
¼” Rabbetted
Inside Bottom of Bookcase
⅛” Lip
1⅜” Face Frame Overhang
¾”
¾”
Bottom of Bookcase