Operation Manual

2.3 Record List
The record list shows the current list off scheduled recordings.
There is also the ability to schedule and create manual
recording by selecting the “OK/tick” key, where you may add
channel, title, date, start time, finish time and duration.
The record list also gives disk space information in terms of
free space and reserved space on the hard disk.
2.4 Library
The library is the archive of the programmes which have
been recorded by you and are stored on the hard disk of
your receiver. There is a selection of thumbnail pictures at
5min intervals which can be used as designated points to
view the recording from. Each different recording will have
a number of thumbnails dependent on the length of the
programme recorded.
Select the recording you wish to view with the navigational
keys and press “Ok/Tick” key to start playback of your
selected recording.
After the recording is finished the receiver shows a still
image, leave the recording by pressing exit.
The number of programmes you can store depends on the
volume of data recorded and can vary from programme to
programme. An overview of the remaining storage capacity
is shown by a bar under the thumbnails where reserved
and free disk space is displayed.
If there is insufficient storage capacity left on the hard disk select the recording you want to delete, and
with the Red “Delete” key remove the recorded data from the hard disk and library list.
The additional coloured buttons are as follows:
Yellow: -operates the LP/SP mode for playback, however if a recording has taken place with subtitles on
then the recording cannot be compressed. In order to compress recordings the subtitle facility must be
turned OFF prior to recording.
Blue: -This function is for archiving selected recordings to a third party recording device such as a VCR
or DVDr. More detailed information can be founding chapter 3.1.
2.5 Sleep Timer
You can use the sleep timer to specify a time (e.g. at night) at which the receiver is to switch over to standby
mode. This is particularly useful if there is no person available at this time to switch off the receiver manually.
There are two ways of setting the sleep timer:
1. Press the “sleep timer” key on the remote control, every press of the key will increase the time by 5
minutes up to a maximum of 180 minutes. Press exit and the receiver will now count down the time set
immediately.
2. Press main menu, select sleep timer with the “OK/tick” key. You can know select up to 180 minutes
by using the “left/right” navigational keys and then use the “up/down2 navigational keys to save and exit,
using the exit key to exit the menu.