User manual

40
See Figure 67: TP Configuration, LNB Type as
example for a dCSS LNB setup.
Figure 67: TP Configuration, LNB Type
After the satellite and LNB type is configured
you can choose below the section “ Select
transponder ” the desired transponder.
Tap on “ Save ” at the bottom to save the
configuration and to go back to Figure 66: TP
Configuration, TP1.
Tap on “ Select ” to apply your selection.
After all TP’s have been assigned and configured
accordingly you have to tap on “ Send to
controller ” in Figure 65: TP Configuration to
send the configuration to the SatPal™ Controller
and to be able to toggle the TP’s as described
in section User Button Function for standalone
mode.
Hint: Satellite data and related transponder data
are provided by the SatPal™ application.
Reset SatPal™ Controller
to factory defaults
Home » SatPal Controller » Reset to Factory
Defaults
In some cases, it might be required to reset
the SatPal™ Controller to the factory default
settings.
Tap on “ Reset to Factory Defaults ” at “ Home
» SatPal Controller ”. A window with a warning
will pop up. To trigger the “ Reset to factory
defaults ” tap on “ Yes ”. See Figure 68 Reset
to Factory Defaults.
Figure 68: Reset to Factory Defaults