User manual

30
Home » Unicable II™ toolbox » upper
rectangle » configuration » Advanced options
By tapping on “ Advanced options ”, you can
set further parameters like LO-frequencies or the
start-up mode, depend on connected device.
By tapping on “ Save Configuration ” the
changes will be saved.
By tapping on “ Commit changes ” the
configuration will be uploaded to the connected
device.
Tap on a UB row to edit the settings of that UB.
See Figure 49: Configuration UB, MSW.
Figure 49: Configuration UB, MSW
By tapping “ Save ” at the bottom the changes
will be saved.
When the download of the configuration data
is completed, a screen as depicted in Figure 48:
Configuration, MSW will be displayed.
Figure 48: Configuration, MSW
On this screen, you can set the type of LNB that
is connected to the Multiswitch (e.g. Quattro or
Wideband), the functionality of the output ports
(options depend on the specific Multiswitch
model, e.g. dual independent Unicable, dual
shared Unicable, Unicable + Legacy) and the
operating mode of the Multiswitch (static or
dynamic). You can see the configured mode of
the device and further down a list of configured
UB’s with assigned Unicable protocol type(s),
occupied IF of mapped UB and bandwidth.