Operation Manual

7
En•
If your Hi-Fi system is equipped with a digital
audioinput,,youmayuseadigitalRCAcinch
cable to connect the electrical (Coax) digital
audiooutputofyourreceiver(socketDIGITAL
AUDIO COAX) to your Hi-Fi or Dolby Digital
system.  The receiver is also equipped with
an optical digital output. If your Hi-Fi system
is equipped with an optical audio input, you
mayuseanopticalcabletoconnectyourHi-Fi
systemtoyourdigitalreceiver(seepicture10).
1.2. Connection to main power
supply
After all the connections are done you can
connectyourdigitalreceivertothemainpower.
Justbeforepluggingapowercableintothewall
connector put the power switch, on the rear
panel(17),inposition0.
1.3. Switching on your receiver
Switchthepowerswitch,(17)ontherearpanel,totheposition“I”.
Theterrestrialreceiverisnowswitchedonandstarting(themessage“Bootingup”isshownonthedisplay).Thiscantakearound20
seconds.Fromnowon,youcanswitchyourreceiveronortostandbyusingthe“Standby”keyontheremotecontroloronthefront
panelofthereceiver.
Note:
Behaviourofthereceiverafterswitchingonorpowerupdependsonthe“Power-upMode”settings(seechapter4.1.1.11PowerUp
Mode)
Note:
Inordertosetthecorrectvideooutputtypeofyourdigitalreceiverpress“Menu“+“Settings“+“Audio/VideoSettings“(seechapter
4.1.1.14Audio/Videosettings)
1.4. Starting the unit for the first time:
Whenyouinstallyourreceiverforthersttimeorwhenyoudoafactoryreset,youwillenterintherstinstallationmode.Theunit
willaskyoutogothroughthefollowingstepstosetuptheunitforproperoperation(torecordandwatchservices):
Step1: aftertherstpoweruporfactoryreset(inusermenu):
Thequickstartguidemenudisplayed:
Selectyourcountry:
press“select”,then“up/down”keysofyourremotecontroltoselectthe•
country,
thenpressagaintovalidateyourchoice•
Selectyourlanguage:•
press“select”,then“up/down”keysofyourremotecontroltoselectthe•
country,
thenpressagaintovalidateyourchoice•
OnceyourselectionsareOK,pressExitontheremotecontrol.
Picture10