Operation Manual

17
En•
4.1.4.5. Daylight saving Time
Thisoptionshowsifitiswinterorsummertimecalculation.Duringthe
wintertimecalculationthisoptionhastobesetto“Off”andduringsummer
calculationthisoptionhastobesetto“On”.Tochancepress“OK”key(6)
andselectoneofthetimeoptionswithnavigationkey“Up”and“Down”.At
theend,press“OK”key(6)toconrmselection.
4.1.5. Antenna Settings
Thisisaplacewhereyoucansetatypeofantennaconnectedtoyour
digitalreceiver.Onthepicture18,youcanseetheantennasettingsmenu.
4.1.5.1. Active Antenna
Press“OK”key(6)andselectoneoftheoptionswiththenavigationkey
“Up”and“Down”.Ifanactiveantennaisconnectedtoyourdigitalreceiver,
select“Yes”otherwiseselect“No”.Attheend,pressthe“OK”key(6)to
conrmselection.
Ifactiveantennaison,thereceiverwillsupplytheactiveantennawith5
voltsDC.Thereceiverisequippedwithshortcircuitprotectionontheactive
antennaoutput.Incaseofashortcircuitwhileactiveantennaison,apop-
upmessage,withinformationaboutshortcircuit,willappear(seepicture
18a).Inthatcase,disconnectantennafromthetuneronarearpanelofthe
receiverandpress“OK”key(6).
Thenextstepistoresolvetheproblem.
4.1.6. Channel Search
Thisisaplacewhereyoucandoautoormanualtuning,autoandmanual
channelsearch(seepicture18).
4.1.6.1. Auto tune
In“Autotune”thereareonlytwooptionsfortheusertosetbeforestaring
autotuning(seepicture20):
1–Searchmode.Hereitisnecessarytoselectbetween“Addnewservices”
and“Replaceservices”.Ifyouselect“Addnewservices”,thereceiverwill,
aftersearchingforchannels,addonlynewTVandradioprogramsintothe
MainTVandmainRadiolists.Ifyouselect“Replaceservices”,thereceive
will,aftersearchingforchannels,completelyreplacetheMainTVandMain
Radiolists.Inthiscase,thepreviouschannellistswillbedeleted.Press
the“OK”key(6)andselectoneofthetuningoptionswiththenavigationkey
“Up”and“Down”.Attheend,pressthe“OK”key(6)toconrmselection.
2–Tuner.Here,theusercanselectonwhichtunerthechannelsearchwill
bedone.Ifonlyoneantennawiththeloopthroughisconnected,theuser
canselecteitherTuner1orTuner2.Ifthedigitalreceiverisconnectedto
twodifferentantennas,theusercanusetheoptionTuner1&2tobeableto
scanservicesonbothantennas.Pressthe“OK”key(6)andselectoneof
thetunerswiththenavigationkey“Up”and“Down”.Attheend,pressthe
“OK”key(6)toconrmselection.
Picture20
Picture18
Picture18a
Picture19
Picture20