Operation Manual

15
En•
4.1.2.4. Digital Audio Out
Usethisoptiontospecifydesiredaudiotypeonthedigitalaudiooutput(SPDIF).Thisoptionisvalidfortheopticalandcoaxoutputs.
Selectthisoptionwiththe“OK”key(6)or“Left”and“Right”directionalkeys.
4.1.2.5. OSD over VCR SCART
UsethisoptiontospecifyifyouwanttohavetheOSDappearontheVCRSCARToutputs.Selectthisoptionwiththe“OK”key(6)
or“Left”and“Right”directionalkeys.
Note:
ThisoptionisavailableonlyifTVSCARTissettoRGB.
4.1.2.6. RF Modulator Audio
Youcanusethisoptiontosetthemodulatorsubcarrierfrequency,whenusingtheRFmodulatoroutput.Selectthisoptionwiththe
“OK”key(6)or“Left”and“Right”directionalkeys.
5.5MHz–PALsystem
6.0MHz–PALIsystem
6.5MHz–SECAMsystem
4.1.2.7. RF Modulator Channel
Usethisoptiontoselectmodulatoroutputchannel.Selectthisoptionwiththe“OK”key(6)or“Left”and“Right”directionalkeysor
selectthisoptionwiththeOKkeyandenterthechannelwanted.
4.1.2.8. Test Picture
Usethisoptiontoactivatethetestthepictureonmodulatoroutput.Select
thisoptionwiththe“OK”key(6)or“Left”and“Right”directionalkeys.
4.1.3. Hard disk Settings
Thisisaplacewhereyoucanformatorsetthebasicparametersofthe
built-inharddisk(seepicture16).
4.1.3.1. Format the hard disk
Warning:
Allstoreddata(recordedprogrammesinthelibrary)willbelostduring
formatting.
Ifyouhavetoformatthebuilt-inharddisk,youcandothisfromthismenu
bypressingthe“Red”functionkey(8).Ashortwarningmessagewillbedisplayed,waitingforconrmation.Incaseyoudonotwant
todoformatthediskpressthe“Red”functionkey(8)or“Exit”key(22).Incaseyoureallywanttoformatbuilt-inharddiskpress
“Green”functionkey(9).Afterthis,youwillbeaskedtoenterafourdigitpincode.Ifyouenteranincorrectpin,“Wrongpincode”
willbedisplayed.Pressthe“OK”key(6)or“Exit”key(22)toturnreturntothepreviousmenu.Oncethecorrectpincodeisentered,
formattingwillbeginimmediately.Youwillthensee“Pleasewait”untiltheformattingiscomplete.Theformattingtimewilldepend
ontheharddisksize.
4.1.3.2. Default Record Folder
Usethisoptiontoselectthelocationwhereallrecordingsshouldbesaved.Press“OK”key(6)andselectoneofthefolders.Hereit
isalsopossibletoopenanewfolderbypressingthe“Green”functionkey(9)“CreateFolder”.Withthenumerickeys2-9,enterthe
nameofthenewfolderandpress“OK”(6).Inthismenu,thelettersbehindthenumerickeysonyourremotecontrolareactivated.
Youmayenterthetextinthesamewayasusingatelephonekeypad.Usethe“Red”functionkey(8)toconrmtheselection.
Numerickey“0”isusedtoexitfromthefolder.
Picture16