Operation Manual

If your Hi-Fi system is equipped with a digital

audio input, you may use a digital RCA cinch

cable to connect the electrical (Coax) digital

audio output of your receiver (socket DIGITAL

AUDIO COAX) to your Hi-Fi or Dolby Digital

system. The receiver is also equipped with

an optical digital output. If your Hi-Fi system

is equipped with an optical audio input, you

may use an optical cable to connect your Hi-Fi

system to your digital receiver (see picture 10).

1.2. Connection to main

power supply

After all the connections are done you can

connect your digital receiver to the main power.

Just before plugging a power cable into the wall

connector put the power switch, on the rear

panel (17), in position “0”.

1.3. Switching on your receiver

Switch the power switch, (17) on the rear panel, to the position “I”.

The cable receiver is now switched on and starting (the message “Booting up” is shown on the display). This can take around 20

seconds. From now on, you can switch your receiver on or to standby using the “Standby” key on the remote control or on the front

panel of the receiver.

Note:

Behaviour of the receiver after switching on or power up depends on the “Power-up Mode” settings (see chapter 4.1.1.12. Power Up

Mode)

Note:

In order to set the correct video output type of your digital receiver press “Menu“ + “Settings“ + “Audio/Video Settings“ (see chapter

4.1.2 Audio/Video settings)

1.4. Starting the unit for the first time:

When you install your receiver for the ﬁ rst time or when you do a factory reset, you will enter in the ﬁ rst installation mode. The unit will

ask you to go through the following steps to setup the unit for proper operation (to record and watch services):

Step1: after the ﬁ rst power up or factory reset (in user menu):

The quick start guide menu displayed:

Select your country:

• press “select”, then “up/down” keys of your remote control to select the

country,

• then press again to validate your choice

Select your language:

• press “select”, then “up/down” keys of your remote control to select the

country,

• then press again to validate your choice

Once your selections are OK, press Exit on the remote control.

Picture 10