Operation Manual

5
En
This short instruction explains the most important functions to ensure that you can directly watch television and make
recordings with your new digital receiver. Please note, additional adjustments may be required.
1.1. Connections
Note:
Do not connect the digital receiver to the main power yet.
1.1.1. Connection to the cable
network*
The cable signalis connected directly to a digital receiver on
the “ANT in” connector of the Tuner 1, by means of a coaxial
cable. Use two loop-through cables (supplied with unit) to
make a loop through between Tuner1 and Tuner2 with the
fi rst cable and between Tuner2 and the RF Modulator with
the second cable (see picture 4)
1.1.2. Connection to the TV set*
The Digital receiver and TV set are usually connected by means of a SCART cable (supplied with unit). Simply connect the two ends of
the cable with the main SCART socket on the TV set and with the TV SCART socket on the receiver, respectively. The SCART connection
ensures that audio and video signals are transmitted to the TV set in optimum quality. In addition, use an RF antenna (coaxial) cable to
connect the “RF OUT“ on the modulator with the antenna input socket of the TV set. In this way, the cable signal connection is looped through
the receiver to the TV set (see picture 5). If the TV set is not equipped with a SCART socket, it is enough to connect an RF antenna (coaxial)
cable as described. The digital TV program currently being received is converted in the receiver to a UHF channel (channel selectable
via the installation menu),
and is transmitted to the
TV set via the RF antenna
cable.
In case that your TV set
is equipped only with a
S-VIDEO input socket, you
can use the S-Video output
on the digital receiver and
connect your TV set via
cable to provide optimum
quality of the video signal.
To provide an audio
signal to the TV set it is
necessary to connect the
Audio L/R output on the
digital receiver with audio input on
your TV set. In addition, use an RF
antenna (coaxial) cable to connect
the “RF OUT“ on the modulator
with the antenna input socket of the
TV set. In this way, the cable signal
connection is looped through the
receiver to the TV set (see picture
6).
In case your TV set is equipped
only with a CVBS input socket,
you can use the CVBS output on
the digital receiver and connect
your TV set via cable to provide
optimum quality of the video
1. Quick installation guide
Picture 4
Picture 5
Picture 6
* Important: RF modulator is an option. Your product does not have the RF modulator.